top of page
Steyr AUG A3/M1/M2 90 Degree Receiver Rail (GREEN)

Steyr AUG A3/M1/M2 90 Degree Receiver Rail (GREEN)

$109.99 Regular Price
$87.99Sale Price

***PLEASE NOTE: The product images above are edited, the green anodized finish will look different from these photos but is close-to-match the green stocked AUG A3/M1. Anodized green rails have a type of mirrored finish that distorts in photos.***

 

Direct replacement for the factory 45 degree receiver rail on the Steyr AUG A3/M1 or M2.  This rail changes the offset to 90 degrees and doubles the usable rail space to twelve 1913 rail sections.  This rail section can utilize the factory T30 hex screws but does come with replacement screws if you so chose.  

 

  • Anodize Color: Green

  • Construction: 6061 T6 Aluminum 

  • Finish: Mil-Spec Class II Type II Teflon Anodized

  • Laser engraved section numbers for mounting and remounting lasers/lights

  • Brings white lights closer to muzzle to reduce barrel shadow

  • Will retain zero on laser devices- see install instructions for more info on best practices

  • Utilizes factory mounting hardware, but includes optional screws

Quantity
SKU: A-1011G

Silver Star Shooting Sports 

AUG A3/M1/M2 90 Degree Offset Receiver Rail Segment (A-1011)  Install Instructions/Notes 

-IMPORTANT:  If you’re mounting any type of IR/laser unit to this rail, mount the unit as close as possible to the receiver screws to reduce any flex and to retain zero.  Mounting an IR unit/laser on the furthest forward position may result in vibration/flex in the aluminum.  The furthest forward slots (9-12) are recommended for white lights only as flexion is normal. 

-Using a light offset mount or rail extension + white light increases the risk of rail flex.  This is normal, but to be noted. 

-Mounting a light on the furthest forward positions (segments 10-12) increases vibrations to the light assembly- make sure your light is tightened down properly and add thread locker if needed.  Pressure switches may wiggle loose under firing as well - we recommend mounting these closer to the mounting screws  on the receiver for less vibration. 

-It is always recommended that a professional gunsmith performs any type of modification to a firearm.

-*PLEASE Make sure your AUG is clear of any ammunition and disassembled/field stripped properly before installation*

-All rails are test fitted prior to shipping, so if yours exhibits some wear on the mounting holes, this is normal.

  • Remove factory rail using a T30 Torx bit.  The factory screws typically can be loosened and removed by hand and shouldn’t require any power tools.  Just some elbow grease.  

  • Using the provided (4MM Hex) or reusing the factory screws, install the 90 degree offset rail into the factory holes in the upper receiver.  

  • Hand tighten each screw until snug or 35 inch pounds of torque if you have a torque wrench.  Do not over tighten as this could damage the mounting holes & receiver.  Thread locker is not necessary but a small amount can be applied if you feel the need!

 

If you run into any issues or have any questions, feel free to email Silverstarshootingsports@gmail.com

bottom of page